Operation Manual

OM-E 2072-09287-00
3-54
NOTE
Before starting, you may want to select a different net to use: see
instructions on page 3-36.
When MultiNet is enabled, you will be prompted for a net number as
soon as you press CALL to start a call.
To execute a bidirectional handshake with an individual station:
1. Press LQA to enter the LQA menu.
BIDR
SOND
LQA
2. Press BIDR. The last called address is displayed. If this is the address
you want, skip directly to Step 6 below.
SEND
PAGE
CHAN
BIDR
1001
I
3. To select a different address, use the UP/DOWN keys to scroll to the required address in the
directory, and then press ENTER to confirm your selection.
or
If the station you want to add to the group is not in the directory:
• Enter the new station using the keypad. If you make a mistake,
scroll to the desired position using < − −
< − −< − −
< − − and/or − − >
− − >− − >
− − >, or clear
(CLR) the whole entry and start again.
SAVE
<--
-->
CLR
BIDR
BU_
• When ready, press SAVE to store the new station in the
directory.
SEND
PAGE
CHAN
DIR
BUD
I
4. Press PAGE if you wish to attach a message to the bidirectional handshake process. After
confirming the message, exclamation mark precedes the name of the called station, indicating
that a message has been attached.
5. Press CHAN if you wish to execute a bidirectional handshake process on a specific channel.
6. Press SEND or ENTER in order to initiate the bidirectional handshake process. During this
process, you will see TO alternating with the number of the channel on which the set up request
is being sent.
NOTE
During the bidirectional handshake process, you can press STOP or
ESC to abort the entire process.
To execute a bidirectional handshake with a net:
1. Press LQA to enter the LQA menu.
BIDR
SOND
LQA