Operation Manual

OM-E 2072-09287-00
3-49
NOTE
When radios in other nets have their MultiNet feature enabled,
AnyCalls may also reach these radios. See details in Appendix C.
You can send three types of AnyCalls (see also description of addressing modes on Appendix C):
• General: the address sent by your radio is @@?. This is a simultaneous call addressed to all the
stations.
• Selective: you specify the last character of the address. This is a simultaneous call addressed
only to the stations whose names (addresses) end with a character you specify.
• Double selective: similar to selective, except that you specify the last two characters of the
address.
To make an AnyCall, first you must select the address to be used for the call.
Micom will wait for responses for a certain time before entering the link state with all the stations that
responded within this interval (the maximum number of stations that are accepted in an AnyCall is
16).
NOTE
Before starting, you may want to select a different net to use: see
instructions on page 3-36.
When MultiNet is enabled, you will be prompted for a net number as
soon as you press CALL to start a call.
To transmit an AnyCall:
1. Press CALL. The radio displays the last called address.
If you see the address you want (that is, you want to repeat the last
AnyCall), skip directly to Step 10 below, otherwise continue as
explained below.
SEND
PAGE
CHAN
CALL
1001
I
2. Press MORE once.
MULT
CALL
1001
I
3. Press MULT to display the first page of special calls.
ALL
NET
GRP
ANY
CALL
I
4. Press ANY.
SEND
PAGE
CHAN
SEL
CALL
ANY
5. Press SEL.
?
ALL
ENDING:_