Operation Manual

OM-E 2072-09287-00
3-42
To send a message during a call (link state):
1. Press PAGE.
NOTE
If this function key is not displayed, you cannot send a
message in the present mode.
PAGE
MON
LINK
1009
I
2. Select or edit the desired message as explained on page 3-40.
3. Press SEND or ENTER to send the message.
SEND
EDIT
CHAN
<->
AMD11
11 AMD MESS
4. The radio now starts the link set up process for this message (this
process is similar to the process used to set up the link for this call).
During this process, you will see TO alternating with the number of
the channel being used.
NOTES
• While the radio is initializing the link, you can press STOP
or ESC to abort the entire process.
• If the link needed to send the message to the selected
station cannot be set up, you will see for a few seconds a
flashing NO LINK message.
STOP
TO
1234
STOP
CH 2
1234
3-12.3.4.6 Other Types of Calls
In addition to calls to individual stations described on the pages 3-36 to 3-41, additional types of calls
can be used to help you call multiple stations (see list on page 3-31).
NOTE
A properly designed address assignment plan is needed to take
advantage of the special ALE calling modes.
The special call types are reached under a special submenu, designated MULT (see Figure 3-7 for its
organization).
To select a special call type:
1. Press CALL.
The radio displays the last called address. This may be a station address, or any other type of
address (for example, AllCall, net, wildcard, etc.).
2. Press MORE once.
3. Press MULT to display the first page of special calls. If the desired call type is located on this
page, press the corresponding function key to select it.
4. If necessary, press MORE again to display the next page.
NOTE
Pressing MORE again return you to the first page of special calls: do
not use the ESC key, as it cancels the MULT option.
5. Go to the page listed below for detailed instructions.