Operation Manual

OM-E 2072-09287-00
3-41
5. The radio now starts the link set up process. During this process, you will see TO alternating
with the number of the channel on which the set up request is being sent (the channel may
change, if the called station does not answer on the first channel(s)).
NOTE
While the radio is initializing the link, you can press STOP or ESC to
abort the entire process.
6. After the link is established, you will see a LINK message. Now you may press the PTT and
start talking.
7. To disconnect the link, press the ESC key (see page 3-36).
3-12.3.4.5 Sending Messages
You can send messages (page) together with the initial call (before the link is set up), and also
whenever necessary while the link is already set up (that is, when your station is in a link with the
destination station).
In the link state, if you are making an individual call, both the receiving and the calling station can
send messages to the other station. This is also true for net calls and group calls.
To transmit an individual call with a message:
1. Initiate a call as explained above (page 3-37 or 3-38) and select the
desired station.
SEND
PAGE
CHAN
CALL
1009
I
2. Press PAGE to add a message. The last sent message is displayed.
SEND
EDIT
CHAN
AMD
5AM
• Press the UP/DOWN keys to scroll to the required message.
SEND
EDIT
CHAN
<->
AMD11
11 AMD MESS
or
• To edit the message, press EDIT and use the keypad to enter a
new message.
SAVE
<--
-->
CLR
AMD
5AM
3. Press SAVE when the message is ready.
4. Press SEND or ENTER to initiate the call.
SEND
PAGE
CHAN
CALL
1009
5. Proceed with the call as explained above (page 3-37 or 3-38).