Operation Manual

OM-E 2072-09287-00
3-38
4. The radio now starts the link set up process. During this process, you
will see TO alternating with the number of the channel on which the
set up request is being sent (the channel may change, if the called
station does not answer on the first channel(s)).
NOTE
While the radio is initializing the link, you can press
STOP or ESC to abort the entire process.
STOP
TO
1234
STOP
CH 2
1234
5. After the link is established, you will see a LINK message. Now you
may press the PTT and start talking.
NOTE
If the link with the selected station cannot be set up, you
will see for a few seconds a flashing NO LINK message.
PAGE
MON
LINK
1234
I
6. To disconnect the link, press the ESC key (see page 3-36).
NOTE
If you want to call again the same station, double-press the PTT to
use the quick-call feature (see page 3-40).
To transmit an individual call with MultiNet ON:
1. Press CALL. The radio displays the current net number, flashing. If you wish to change the
currently used net, press the UP/DOWN keys or enter the net number on the keypad.
2. Press ENTER to confirm the net number.
3. The radio displays the last called station.
Press the UP/DOWN keys to scroll between stations, or use the keypad to enter a station name
and then press SAVE or ENTER when the required station name appears.
4. Press SEND or ENTER to initiate the call.
5. The radio now starts the link set up process. During this process, you will see TO alternating
with the number of the channel the set up request is being sent (the channel may change, if the
called station does not answer on the first channel(s)).
NOTE
While the radio is initializing the link, you can press STOP or ESC to
abort the entire process.
6. After the link is established, you will see a LINK message. Now you may press the PTT and
start talking.
7. To disconnect the link, press the ESC key (see page 3-33).