Operation Manual

OM-E 2072-09287-00
3-36
To remove an address from the stack:
The radio automatically removes an address from the stack in the following cases:
• When the operator calls a station registered in the caller stack, all stack calls containing that
address are erased from the stack, regardless of whether the call was returned from within the
stack or during an individual call.
• The stack can contain up to ten addresses. When the stack is full and a new address comes in,
the new address replaces the oldest address in the stack.
In addition, you can manually remove an address from the stack as follows:
1. Press STAK.
2. Use the UP/DOWN keys to scroll to the required call.
3. Press ERAS.
4. Press YES to confirm or, NO to cancel the deletion.
3-12.3.3 Disconnecting Calls
When you are in the link state, your radio can communicate with at least one other ALE station.
To disconnect an incoming call:
Press the ESC key. This disconnects the link and returns the radio to the
mode used before the link was established. When you disconnect a link,
you can instruct the other station(s) to return to the working mode they
were in before they entered the link state. This feature is called Home
Acknowledge, and can be programmed.
END CALLING
If Home Acknowledge is enabled:
• In an individual link, each of the stations in the link can transmit the Home Acknowledgement to
instruct the other stations to disconnect the link.
• In a net/AnyCall link, the Home Acknowledgement can only be transmitted by the radio which
initiated the call.
3-12.3.4 Transmitting Calls in ALE Mode
To transmit an ALE call, you must specify the destination. In general, the destination consists of a net
and one or more stations (members of the specified net):
• When the MultiNet function (Appendix C) is disabled, the
destination net is always the currently selected net (its number is
displayed on the LCD while the radio is scanning). Therefore, if you
do not want to select a different net, you can skip directly to the
selection of the destination station(s).
CALL
LQA
MON
ALE
NET 1 1
MON
USB
IATU
• When the MultiNet function is enabled, first you must always select a net and then the
destination station(s).
To expedite the transmission of an AllCall, you can send a global AllCall by pressing the P/ESC key
for a few seconds.
Micom stores the last called address, so you can simply press the PTT twice in rapid sequence (double
pressing) to call again that address. This also applies to AllCall, and therefore after sending AllCall for
the first time, you can send it again by double pressing the PTT.
NOTE
If you want to monitor the call set up process on the speaker and be
alerted by a beep when the link is set up, turn the monitor on, using
the MON key.