Operation Manual

OM-E 2072-09287-00
3-33
NOTE
When an AllCall is received, no link is actually established but you can
hear the calling station.
If the received call includes a message, an exclamation mark precedes the station name, and the name
is followed by a colon and the message.
If the calling station name and message are too long and do not fit in the display, press < − >
< − >< − >
< − > to enter
the View mode, where you can scroll right and left to display the whole message.
To display LQA for the received call:
Press LQA. You will see the channel in use, and its LQA score.
3-12.3.2 The Link State
After the radio successfully receives or transmits a call, it is in the link state.
If the call was received from another radio, the display includes the word
FROM in the first line, as well as the name of the station which initiated
the call (if a message has been received, it is also displayed).
LQA
MON
FROM
ABC
If the call was initiated by your radio, the display includes the word LINK
in the first line, as well as the destination address.
PAGE
MON
LINK
1234
I
3-12.3.2.1 Link State Options
While in the link state, you can operate the following functions using the function keys.
NOTE
The change of link options is temporary. When you exit the link state,
all the changed parameters will be lost.
Option Description
< − >
< − >< − >
< − >
Activates the View mode, where you can view the entire station address.
Page
Enables you to select a message to be sent to the station you are linked to. After a
message is selected, you can edit it. The PAGE function is not available when receiving
an AllCall.
LQA
Displays the channel on which the link was established, and the LQA score of the current
link. If the name of the station you are linked to is not in your directory, this function will not
be available.
The LQA key is displayed only if you established the link in the ALE mode (in the Channel
mode, this function is not available, because the call is received/transmitted on the current
channel).
MON
Turns on and off monitoring by means of the speaker.
RPL
Replaces the currently-used channel with a channel with a better LQA score.
The radio disconnects the link, replaces the channel being used, and initiates the call once
again. The RPL function is available only for individual calls, and only for the call initiator.
The RPL key is displayed only if you established the link in the ALE mode (in the Channel
mode this function is not available, because the call is received/transmitted on the current
channel).