Operation Manual

OM-E 2072-09287-00
3-20
3. If you are using the SMPX, RXO or TXO frequency type, and you wish to use the displayed
frequency, press ENTER.
or
Enter a new frequency. There are two ways to change the frequency.
Method A:
• Press LEFT/RIGHT to move the cursor to the digit in the frequency value that you want
to change. The blinking digit indicates the cursor location.
• Press UP/DOWN to scroll to the value of your choice.
Method B:
• Type the frequency on the keypad. The frequency digits blink,
indicating that the selection has not yet been confirmed.
• When the desired frequency is displayed, press ENTER to
confirm your choice.
BACK
CLR
SMPX
F
12,345.67
USB
IATU
SQ
4. If you are using the DPLX frequency type, the frequency displayed
first is the Rx frequency. If you want to use the displayed frequency,
press ENTER.
SMPX
DPLX
RXO
TXO
DPLX
R
15,000.00
USB
IATU
SQ
or
Enter a new frequency.
The frequency digits blink, indicating that the selection has not yet
been confirmed.
When the desired frequency is displayed, press ENTER to confirm
your choice.
BACK
CLR
DPLX
R
23,456.00
USB
IATU
SQ
5. After confirming the Rx frequency, the Tx frequency blinks in the
display.
If you want to use the displayed Tx frequency, press ENTER.
SMPX
DPLX
RXO
TXO
DPLX
T
14,000.00
USB
IATU
SQ
or
Enter a new frequency.
The frequency digits blink, indicating that the selection has not yet
been confirmed.
When the desired frequency is displayed, press ENTER to confirm
your choice.
BACK
CLR
DPLX
T
12,345.67
USB
IATU
SQ
6. Press ENTER to confirm the frequency type and the frequencies you
have set.
T/R
BAND
SQ
DSP
FREQ
F 30,000.00
I
USB
IATU
AGC