Operation Manual

OM-E 2072-09287-00
2-8
To install the antenna:
1. Remove cover from the WHIP connector on the Micom front panel.
2. Visually check the connector for dirt or damage. Clean if necessary.
3. Screw antenna support AB-591 into the Micom WHIP connector. Tighten by hand only.
4. Extend the whip, and secure all sections by inserting them one into the other by hand.
5. Screw whip antenna sections into antenna support, AB-591.
NOTE
When the radio set is not in use, you may fold the antenna without
disconnecting it from the WHIP connector. In this case, fasten the
folded sections using the safety belt supplied with the antenna. Before
starting transmission, make sure to release the safety belt and extend
the antennas.
To remove the whip antenna, perform the above tasks in the reverse order.
CAUTION
When folding the whip, always start with the upper section, otherwise
it may be damaged.
2-3.4 Connection of Audio Accessories
Connect the handset, FMN5501, to either of the AUDIO connectors on the front panel of the Micom.
You may secure the handset to the front side of a supporting strap.
If the optional LS-108M loudspeaker is used, insert it in the pocket and secure it with the straps, or
attach it with a strap passing through its top and bottom hooks. Connect the loudspeaker cable to one
of the AUDIO connectors on the front panel of the Micom. Route the audio cables through the
dedicated passthrough slots on the back of the harness.
2-3.5 Wearing Backpack Carrying Harness
To wear backpack:
• Put harness on your back by inserting arms through shoulder straps.
• Tighten shoulder straps if necessary by adjusting the strap buckles.
• Buckle waist straps to belt and adjust to size.
• Adjust the breast strap length and then attach the strap.
At this stage, the Micom Pathfinder is ready for use as a manpack radio set.
2-3.6 Operating Micom Pathfinder on Ground
To operate the Micom Pathfinder on the ground, place the backpack on a flat, dry area, and deploy the
rear support to stabilize the harness in a standing position.
For safety, and to achieve best perform, ground the Micom Pathfinder: drive the grounding spike into
the ground close to the radio, and then connect the grounding strap between the front panel grounding
post and the grounding spike.
2-4. USING THE FAA5548 TACTICAL DIPOLE ANTENNA
In static operation, the Micom Pathfinder can be used with an FAA5548 tactical dipole antenna. Refer
to Appendix B for FAA5548 installation and operation instructions.