Operation Manual

OM-E 2072-09287-00
2-7
1. Insert the threaded stud of the AT-1000 in
the AD-1000P hole.
2. Turn the captive nut of the AD-1000P
clockwise to fasten the AT-1000 to the
adapter.
3. Remove the cover from the GPS
connector of the Micom.
4. Connect the TNC connector of the
CG-5602 cable to the AT-1000 connector,
and tighten the connector.
5. Plug the connector at the other CG-5602
end into the Micom GPS connector.
Turn Clockwise to
Fasten Antenna
AD-1000P
AT-1000
Captive
Locking Nut
2-3.2.4 Orienting the GPS Antenna Toward the Sky
When the GPS function is used, the GPS antenna must point toward the sky at all times.
The AD-1000P has two positions:
• Standing position: directs the antenna toward the sky when the Micom operator stands or walks.
• Prone position: directs the antenna toward the sky when the Micom operator lays on the ground.
To rotate the GPS antenna from the standing
position to the prone position:
1. Pull the AD-1000P lock pin out.
2. Turn the GPS antenna counter-clockwise.
3. Release the lock pin, and make sure it snaps
into the corresponding hole locking the antenna
and preventing it from rotating.
The same procedure is used to return the GPS
antenna to the standing position.
CAUTION
Make sure that the CG-5602 cable is
not pulled nor stressed when the
AD-1000P is rotated.
2. Turn GPS Antenna
3. Release Pin
AT-1000
To GPS Connector
CG-5602
1. Pull Lock Pin Out
AD-1000P
GPS Antenna in Standing Position
To GPS Connector
CG-5602
GPS Antenna in Prone Position
2-3.3 Installation of Whip Antenna
Before starting make sure that the top protection flap is fully open.