Operation Manual

OM-E 2072-09287-00
2-4
Spare Battery
Compartment
Transceiver Restraining
Side Straps
(4 places)
Top Transceiver
Restraining Straps
Passthrough Slots
for Cables
Front Flap
in Open Position
Cable Storage
Pocket
Internal
Storage
Pockets
Restrainer
Figure 2-3. Carrying Harness with Front Flaps Raised
2-3.2.2 Installation Procedure
1. Place the carrying harness on a clean, level surface.
2. Release the four straps (two on each side).
3. Unzip the front flap, and then raise the flap as shown in Figure 2-4.
4. If necessary, store a spare battery in its storage compartment.
5. Release the two top transceiver restraining straps, and the four side restraining straps.
6. Orient the transceiver as shown in Figure 2-4, and then place it in position, behind the restrainer
plate.