Operation Manual

OM-E 2072-09287-00
2-2
2-3. MICOM PATHFINDER ASSEMBLY PROCEDURE
The assembly of a Micom Pathfinder radio set and its preparation for operation includes the following
steps:
• Installation of Micom battery
• Installation in carrying harness
• Installation of antenna and audio accessories
• Wearing the carrying harness.
2-3.1 Installation of Battery
1. Check that the volume/power control
of the Micom Pathfinder is set to the
fully counter-clockwise detent
position, OFF.
2. Place the unit face down on a clean,
flat surface.
3. Release the two clamps holding the
battery cover on the bottom of the
unit and remove the cover.
4. Remove old battery, if any.
5. Align battery connector with the two
power pins protruding from the
bottom of the unit, and push the
battery in place.
6. Visually check battery cover for dirt
or damage. Clean if necessary.
7. Reinstall the battery cover and fasten
with the two clamps.
Battery
Connector
Battery, FRN8577
Battery
Cover
Figure 2-1. Installing the Battery