Operation Manual

OM-E 2072-09287-00
A-3
A-4.2 Preparations for Charging
1. Place the battery charger on a flat, clean surface, protected from sun and rain.
2. Insert the DC output plug of the AC/DC converter into the DC input connector of the charger
unit.
3. Connect the AC power cable to the power input connector of the AC/DC converter, and then
connect the other end of the power cable into an AC outlet.
A-4.3 Charging Process
1. When ready to charge a battery, connect the battery to be charged to the battery charger: insert
the DC output plug of the charger unit into the FRN8577 charging socket and press firmly to
mate (the connectors will mate only if plug is correctly oriented).
2. The status indicator of the charger unit will start flashing in green.
NOTE
If the battery is faulty, the status indicator will start flashing in red. In this
case, no charge current is supplied to the battery. Disconnect the power,
and replace the battery.
3. The charger now operates automatically. When the battery is fully charged: the status indicator
of the charger unit lights steadily in green, with short blinks every 30 seconds.
4. At this stage, disconnect the battery from the charger. The status indicator continues to light
steadily in green (with short blinks every 30 seconds), to indicate that the charger is in standby.
However, if necessary, you may leave the battery connected to the charger.
5. If the charger is no longer needed, disconnect the power cable from the AC outlet, and then
disassemble the charger by disconnecting its components.