Installation Instructions

OM-E 2072-09287-00
3-52
5. Press WILD to start.
SEND
PAGE
CHAN
SEL
CALL
WILD
6. Press SEL.
?
WILD
_
NOTE
If you try to send (SEND) the call without first selecting an address,
your attempt is rejected and you see for a few seconds NOT PROG.
7. Select the desired address:
• To insert a wildcard, press ?
• Enter the desired characters using the keypad.
?
<--
-->
CLR
WILD
?135?
8. Confirm your selection by pressing ENTER.
SEND
PAGE
CHAN
SEL
CALL
?135?
9. Press PAGE if you want to attach a message to the call.
10. Press CHAN if you want to initiate the call on a specific channel.
11. Press SEND or ENTER to initiate the call.
NOTE
If the selected group does not include at least 2 stations, your request
is rejected and you will see for a few seconds AT LEAST 2.
The radio now starts the process. During this process, you will see TO alternating with the
number of the channel on which the request is being sent.
NOTE
You can press STOP or ESC to abort the entire process.
12. After a delay, you will see LINK with the wildcard address flashing.
PAGE
LQA
MON
LINK
?135?
I
13. Confirm the link set up by pressing ENTER or the PTT. The address
stops flashing, and you can start talking.
PAGE
LQA
MON
LINK
?135?
I