Installation Instructions

OM-E 2072-09287-00
3-50
NOTE
If you try to send (SEND) the call without first selecting an address,
your attempt is rejected and you see for a few seconds NOT PROG.
6. Select the AnyCall address:
• To send a general AnyCall, press ?.
?
ALL
ENDING:_
• To send a selective AnyCall, enter the desired character (any
character except #, @ or ?).
?
CLR
ALL
ENDING:_
• To send a double-selective AnyCall, enter two characters.
?
<--
CLR
ALL
ENDING:59
7. Confirm your selection by pressing ENTER.
SEND
PAGE
CHAN
SEL
CALL
ANY @@ ?
SEND
PAGE
CHAN
SEL
CALL
ANY @@ 2
SEND
PAGE
CHAN
SEL
CALL
ANY @ 59
8. Press PAGE if you want to attach a message to the call.
9. Press CHAN if you want to initiate the call on a specific channel.
10. Press SEND or ENTER to initiate the call.
The radio now starts the AnyCall process. During this process, you will see TO alternating
with the number of the channel on which the request is being sent.
NOTE
You can press STOP or ESC to abort the entire process.
When an AnyCall is transmitted, the initiator of the call receives an
indication of each station answering the call (its address flashes in the
display, until replaced by the next answering station).
LINK
1111
11. After a programmed interval (or after 16 stations answer, whichever
comes first), the link is established. Now you can start talking.
PAGE
MON
LINK
ANY
I