Installation Instructions

OM-E 2072-09287-00
3-14
3-6. USING THE CHANNEL MODE
The Channel mode is used to operate on a channel already programmed in the Micom.
The following sections describe how to use the Channel mode.
3-6.1 Channel Mode Options
In the Channel mode, you can operate a variety of functions and options which can help eliminate
noise, or otherwise assist reception and/or transmission.
The structure of the CHAN menu is shown in Figure 3-4.
BAND
SQ
DSP
CH 6
CH 6CH 6
CH 6
F
FF
F
16,000.00
16,000.0016,000.00
16,000.00
I
USB
VCD
PVT#
DGTL
CLR
Option
TXM
For duplex
and TX only
channels
BAND
DSP PWR
LOW
MED
HIGH
MAX
CLAR
ON
OFF
SQ
ON
OFF
MODE AGC
SLOW
FAST
OFF
More
BW
2.1
2.7
3.0
3.3
LSM
CW
RCLV
More
CALL
SEND
PAGE
More
ALL
NET
GRP
ANY
WILD
SELF
LSB
USB
SSB
AME
PLT
ON
OFF
ON
OFF
-200
OFF
+200
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
CLIP
NB
ATTN
.
.
.
.
NF
Only for ALE Enabled
MON
ON
OFF
SEND
CHAN
SEND
PAGE
CHAN
SEL
SEND
PAGE
CHAN
SEL
SEND
PAGE
CHAN
SEL
SEND
PAGE
CHAN
SEND
PAGE
GLOB
SEL
More
MULT
GPS
Option
Figure 3-4. Channel (CHAN) Menu
NOTES
• The changing of channel options is temporary. When you select a
different channel, all the current options will be lost and replaced
by the values configured for the newly selected channel.
• The RCLV item appears only if the received signal level display is not
permanently enabled using MENU>PROG>RAD>PRMT> RCLV.
• The GPS item appears only if your radio includes the GPS option.
The following table presents a concise description of the options available in the Channel mode.
Option Description
TXM
Press to switch to the channel transmit frequency (appears only when using a duplex or Tx
only channel). After releasing, the radio returns to the receive frequency.
For a Micom with the internal vocoder option, this position displays PVT, DGTL, or CLR.
Pressing F1 then toggles the operating mode of the vocoder.