Installation Instructions

OM-E 2072-09287-00
4-13
Option Description
ILNK
Inlink: enable/disable the inlink facility, which enables notifying other call participants
when each participant disconnects from the link. All participants must be programmed to
use the same selection (either YES or NO).
Do not enable the inlink function when communicating with a radio that does not support
the full ALE capabilities in accordance with MIL-STD-188-141B.
BDLK
Bidirectional link: enable/disable automatically setting up a link on the best channel after
a bidirectional handshake with an individual station.
The ALE options have the following factory-default values:
• PTT Timeout
No timeout
•
••
• Alert
Yes
• External Alarm
Yes
• Auto Address
No
• Quick Call
Yes
• Minimum LQA score
0
• Accept Link Timeout
Yes
• MNT
Yes
• MxCH
Auto
• ANY
Yes
• WILD
Yes
• AMD
Yes
• ILNK
No
• BDLK
No
When configuring ALE options, you do not need to define all parameters: change only those for which
the factory-default values are not suitable.
4-4.6 Auto Dial Parameters
Auto Dial enables you to set shortcuts for calls to frequently called stations, with or without
automatically attaching messages when a station is called:
•
••
• AUTO
Used to configure up to 10 autodial codes, numbered AUTO 0 to AUTO 9.
•
••
• AMD
Used to prepare AMD messages for sending when an autodial code is used. See
message preparation details in Chapter 3.
NOTE
If a message is attached to the address, an exclamation mark
precedes the address.