Manualshelf

Service Manual

ManualsBrandsElbit Systems Land and C4I - Tadiran ManualsElectronicsLicensed Non-Broadcast Station Transmitter - MICOM Z-Dash
71727374757677787980
MM-E 2072-09333-00
3-24
6. Clean the remnants of heatsink compound from the areas identified in Figure 3-14, and then
spread a thin layer of fresh compound.
7. Position the replacement LORD module over the lower RFI contacts, place them together in
their original positions on the LORD base, and then fasten the LORD module with the two
heatsink screws removed in Step 4 above.
8. Position the upper RFI contacts over the LORD module, place the shield over the assembly, and
then fasten the shield with the eight screws removed in Step 2 above.
9. Reconnect the battery harness to connector J4 on the LORD module.
3-6.1.2.5 Reinstalling the LORD Assembly
1. Insert the LORD assembly in the corresponding slot of the body assembly, slide it halfway, and
then insert the GPS connector in its hole in the rear panel.
2. Fasten the GPS connector with its nut. The recommended tool is Mfg. Cat. No. 2072-08013-00.
3. Push the LORD assembly fully into the body assembly, and then fasten the ACCESSORY
connector to the rear panel with its two fasteners.
4. Fasten the two LORD handles to the body assembly with the two original screws.
5. Reconnect the coaxial RX and TX cables to the LORD module connectors.
6. Reconnect the flat cable connected to the HI POWER module.
7. You may now close the Micom-Z case in accordance with para. 3-6.1.1.
3-6.1.3 Replacing the HI POWER Module
The HI POWER module is installed on a heatsink, fastened to the body assembly by nine screws. The
module is also attached to the VDC IN connector, and is connected by a coaxial cable to the ANT
connector.
CAUTION
The ANT and VDC IN connectors are attached to the rear panel.
3-6.1.3.1 Removing the HI POWER Module
1. Remove the LORD module in
accordance with para. 3-6.1.1.
2. Release the two fasteners of the VDC
IN connector.
3. Release the nut of the ANT connector.
4. Disconnect the cables connected to the
front side of the HI POWER module.
Nut
Fasteners
5. Refer to Figure 3-15, and release the nine screws fastening the module to the body. Keep screws
and washers for reuse.
6. Insert the tip of a narrow blade screwdriver in the slot located under the HI POWER module
heatsink, and press lightly to raise the module.
7. You can now pull the HI POWER module out: after moving the assembly by 2 to 3 centimeters
(one inch), push the ANT connector in, and then continue to pull out the HI POWER module.
Make sure that the ANT connector is pulled out together with the assembly as the HI POWER
assembly is retracted.