Operator's Manual

OM-E 2072-09689-00
3-11
3-5. INSTALLATION OF TRUNK-MOUNT MICOM-Z MODEL ON BASIC TRAY
For trunk-mounted Micom-Z radio sets, only the control head, the speaker, and the microphone are
installed in the passenger compartment of the vehicle. The radio transceiver is usually installed in the
trunk of the vehicle, together with the antenna tuner.
Figure 3-11 shows a typical installation diagram for the trunk-mount Micom-Z model.
NOTES
1. See para. 3-6 for details regarding installation on the cooling tray.
2. When using the FAD1410, refer to its Owner’s Guide for
installation instructions.
VDC IN
Connector
Trunk Compartment
Passenger Compartment
ATU
ANT
Connector
Microphone
Control Head Cable
Control Head
ACCESSORY
Connector
GPS Antenna
Connector
GPS
Antenna
(Option)
Outside the Car
Whip
Antenna
Basic
Mounting
Tray
Fuse Housing
Extension
Leads
Red
Red
Black
Black
DC Power Cable
12V Battery
Grounding
Strap
Thoroughly
Clean this Area
Lockwasher
3/16” Hole
No. 14x3/4”
Self-Tapping
Screw
Vehicle
Frame
Ground
Ferrite
Ferrite
Grounding
Strap
Antenna
Cable
Speaker
Jack
Speaker
Plug
Speaker
Figure 3-11. Typical Trunk-Mount Micom-Z Installation Diagram
Figure 3-12 shows typical locations of the components installed within the vehicle.
The trunk-mount model requires the connection of two cables across the length of the vehicle because
the radio transceiver is located in the trunk.