Operator's Manual

OM-E 2072-09689-00
2-53
2-13.3 Using the CCIR Scanning Mode
2-13.3.1 Preparations
To activate the CCIR scanning mode:
1. Access the CCIR menu: MENU > CCIR.
CCIR
CALLSCAN
2. Press SCAN to access the group selection screen. The group
identification blinks on the display.
NOTE
If no scanning groups have been programmed, EMPTY
appears in the display. Groups are programmed using the
MRC.
-CCIR
GROUP A 8
CALL GRPSTOP
MON
3. Select a scan group, and then press ENTER to confirm.
The transceiver begins scanning the channels in the selected group
(the changing channel number appears to the right of the group
identification).
-CCIR
GRP B 4
CALLSTOP
GRP
MON
To stop scanning:
1. After scanning is enabled, STOP appears in the menu bar. Press
STOP to stop scanning.
Note that STOP has been replaced by SCAN.
2. When scanning is stopped, you can change the operational
parameters, for example, squelch state, DSP parameters, etc.
STOP
GRP B 1
MONSCAN SQ
DSP
3. To resume scanning, press SCAN.
-CCIR
GRP B 4
CALLSTOP
GRP
MON
To change the scanning group:
1. Press GRP to access the Group selection menu.
2. Select a scan group and press ENTER to confirm. The transceiver
begins scanning in the new group.
STOP
GRP A 1
CALLSCAN
GRP
MON
To mute the speaker:
1. Press MON.