User guide

12
Wash options
Saving water – Eco option
Press the ECO option to save large amounts of water.
The
ECO option uses an Eco Spray rinse. Use this option
when you want to use less detergent and less water.
This option is not recommended if you have low
water pressure or sensitive skin.
The
ECO option has not been designed to be used
with fabric softener as it does not have a second deep
rinse to dispense the softener correctly.
Note: the
ECO option is only available on the REGULAR
and
HEAVY DUTY cycles. If you try to select these options
on the
WOOL or DELICATE cycle, your Smart Drive™ will
skip over the option. The
ECO option will take slightly
longer than a normal spray and deep rinse.
There are some wash loads that may not suit being
washed using the
ECO option. For instance, loads that
have a lot of sand or sawdust in them or garments
where the colour still runs from them.
Tips for water saving
Full loads are more efficient than part loads.
Use the
ECO option. (Refer above).
Adjust the rinse option on
REGULAR, HEAVY DUTY and
WOOL cycles to one deep rinse. (Refer to page 19).
Wash larger loads
Spin Hold
Use the SPIN HOLD option to:
Remove drip dry garments from a mixed load before
the wash goes into spin.
Minimise the clothes creasing when they are left to sit
in the bottom of the bowl at the end of the cycle.
When you have selected
HOLD, your Smart Drive™ will
pause at the end of rinse, beep and the spin light will
flash to tell you that it is waiting for another instruction.
Press
START/PAUSE to begin the spin.
Fig.14 Selecting ECO option
Fig.15 Selecting SPIN HOLD option