Owner`s manual

WATER FILLING METHOD
The condensing water from the appliance is recycled to improve efficiency through cooling condenser.
At the same time it could lower the noise and save energy.
When the condensing water is not enough for pumping, the water filling indicator will illuminate. You
may add water to the water tank as shown below.
Note: Filling water into the water tank helps to reduce the heat of the compressor. It is advisable to maintain the
water level to protect the compressor from overheating. However, adding water is not necessary to let the
appliance to work.
DRAINAGE METHOD
This appliance is equipped with automatic water vaporization system. The condenser is cooled
with the circulating of condensing water to improve cooling efficiency and energy saving.
When the water is full, the water full indicator will lights and the compressor will stop working. The
buzzer will buzz 10 times every 5 minutes until the water is below the high level or drained by hand.
When the alarm stops and after three minutes restart delay, the unit will continue to work normally.
Before you empty the unit, please switch off the appliance and remove the plug from the power supply.
Uncap the lid and remove the rubber plug on the drainage port to let the water drain out from the unit.
Once drained, put the rubber plug back and screw the lid up and switch it on. Please wait three
minutes restart delay before the compressor starts to work normally.