Owner`s manual

ASSEMBLE THE APPLIANCE

(Figure 1)

 Place the motor base on a flat, stable and heat

resistant surface. Ensure that the control switch

is turned to speed “0” position.

 Fit the spout cover on the motor base with the

juice outlet spout at the left hand side (refer to

figure 1).

(Figure 2)

 Hold the stainless steel grater and filter

assembly as per figure 2.

 Install the stainless steel grater and filter

assembly into the motor base.

 Twist the filter assembly and gently push down

until it is seated on the motor base.

NOTE: The top edge of the grater

should not be

higher than the edge of the spout cover when

properly installed.

WARNING:

Beware when handling the stainless steel grater

and filter. Do not touch the small sharp blades

inside the filter!

(Figure 3)

 Place the juicer cover on top of the spout cover

so that the facing of the pulp chute is on the

opposite side of the juice outlet spout.