Specifications

POSSIBLE GAS CONNECTIONS

GAS CONNECTION WITH A RUBBER HOSE

Important!

A rubber hose connection shall only be made if permitted by the applicable local

regulations.

The gas connection is made up of:

• theterminalttingoftheinletpipe;

• the brass connector;

• sealing washers;

• the appropriate hose holder (for Natural/Town gas or LPG).

Important! If the brass connector is not already tted on the appliance (but sup-

plied in a separate kit), screw that connector to the terminal of the gas inlet pipe

before starting the connection to the gas supply.

Use two spanners when connecting the brass connector.

Connecting the cooker to Natural or Town gas

1. Ifnotalreadytted,ttheNatural/Towngashoseholderontheinletpipe,makingsure

that you place the sealing washer between them (as shown in Fig. 8.2).

THE PIPE DOES NOT CROSS THE REAR PANEL OF THE COOKER.

IN CASE OF CROSSING THE BACK PANEL, ENSURE THE PIPE IS POSITIONED

CLOSE TO THE BOTTOM PART OF THE APPLIANCE.

IF CONNECTING THE APPLIANCE TO A GAS CYLINDER POSITIONED INSIDE THE GAS

COMPARTMENT, FOLLOW ALSO THE INFORMATION AS PER CHAPTER “GAS CYLINDER

CONNECTION” AND FIGURE 8.4.

Fig. 8.1

CONNECTING THE APPLIANCE TO THE GAS SUPPLY

The gas connection must be carried out by an authorised person according to the relevant

standards.

Ensure that the room in which the cooker is to be installed is adequately ventilated, in com-

pliance with applicable regulations.

• Connectthecookertothegasmainsutilizingrigidorexiblepipes.

• The gas supply is connected at the rear of the cooker to the terminal of the gas inlet

pipe (Fig. 8.1).

 The connection pipe must not cross the rear of the appliance.