Owner`s manual

Witheachwashcycle.
Compartment
For pro gramm es with pre-wash only.
(Follow the user instructions !)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models w ith water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programme
Close the door, turn on the water tap and press the Start/Pause button. The machine will start working
after about 10 seconds.
Running the dishwasher
Switch off the applia nce
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 min utes) before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower basket.
Changing the programme
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then l oad the baskets. Refer to the dishwasher loading instr uct ions.
Press the Programm e butto n until the selected progra m me li ghts up .
( See the section entitled Operationg instruction )“”
When the working cy cle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the Po wer button.
If the appliance is switched
off during a wash cycle.
Op en t he do or car ef ull y.
Hot st eam may escape
when the door is opened!
If the appliance is switched off during a wash cycle, when switched
on agai n, plea se re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance Press the Power switch button to switch on the appliance, Op en the door.
1.Press the star t/pause button to stop the machine.
2.Open the door.
3.Add the forgotten dishes.
4.Close the door, then press the start/pause butto n, the dishwasher will
s tart running a gain after 10 seconds.
For detailed operating method read the corresponding content on the instruction manual.
1. A running cycle can o nly be modified if it has been running for a short time. O therwise the detergent
m ay have alre ady be en released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the Start/Pause button ,than press the program button more th an 3 s econds to cancel the
running programme.
3. Select a new programme.
4. Restart the dishwash er.