User manual

www.elationlighting.com!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!V!!!!!!!!!!!!!!!!!!#!$%&'!(#)!**+!,-./!012314!567
GENERAL GUIDELINES
• NEVER OPEN THIS FIXTURE WHILE IN USE!
• During the initial operation of this fixture, a light smoke or smell may emit from the
interior of the fixture. This is a normal process and is caused by excess paint in the
interior of the casing burning off from the heat associated with the lamp and will
decrease gradually over time.
• This fixture is a professional lighting effect designed for INDOOR / DRY LOCATIONS
ONLY on stage, in nightclubs, theatres, etc.
• Please make sure there are NO FLAMMABLE MATERIALS close to the fixture while
operating, to prevent any fire hazard.
• The fixture must be installed in a location with adequate ventilation, at least 1.5 feet
(.5m) from adjacent surfaces. Be sure no air ventilation slots are blocked.
• Do not attempt installation and/or operation without proper knowledge how to do so.
• Do not permit operation by persons who are not qualified for operating this type of
theatrical fixture. Most damages are the result of operations by nonprofessionals.
• Consistent operational breaks may ensure the fixture will function properly for many
years to come.
• Do not shake fixture, avoid brute force when installing and/or operating the device.
• Always install the fixture with an appropriate safety cable. When installing the fixture
in a suspended environment, always use mounting hardware that is no less than M10
x 25 mm, also be sure the hardware is insert in the pre-arranged screw holes in the
bracket of the fixture.
• Please use the original packaging and materials to transport the fixture in for service.
• DO NOT TOUCH the housing bare-hand during its operation. Turn OFF the power
and allow approximately 15 minutes for the fixture to cool down before replacing or
serving.