User manual

www.elationlighting.com!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!QV!!!!!!!!!!!!!!!!!!#!$%&'!(#)!**+!,-./!012314!567
Step 2 – Editing Programs.
The control will store a maximum of 10 programs. A program can store one or a maximum of
64 scenes. Keep in mind that a scene can only be access when it is stored inside one of the
10 available programs.
• Access the main menu and toggle to “Edit Programs” which is menu function 12.
• Then press ENTER and toggle to “Program 1”.
• When you get to the “Program 1” function press ENTER. The screen will then
change to “Edit Steps 01”. Use UP and DOWN to toggle through the scenes
created in “Step 1”. Press ENTER to add a scene to the program. Pressing ENTER
will automatically lock the selected scene into the programs’ memory. Repeat the
process until all the desired scenes have been added to the program. Each program
can store a maximum of 64 scenes.
• To test the program, access “Program Test” in the “Program Edit” menu function.
Step 3 – Playing a Program
To initiate a program follow the procedure below:
• Access the main menu and press UP and DOWN to toggle to “Function Mode”
and press ENTER.
• In the next screen select “Auto Program” and press ENTER.
• There are now two selections, “Master” and “Alone”. Select “Master” when
running multiple fixtures in a Master/Slave configuration. See “Master/ Slave
Operation” section on page 35 for proper set-up instructions. Select “Alone” when
running a single fixture or when multiple fixtures in stand-alone mode. See
“Stand-Alone Operation” section on page 34 for proper set-up instructions.