User manual

www.elationlighting.com!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!"V!!!!!!!!!!!!!!!!!!#!$%&'!(#)!**+!,-./!012314!567

SPOT

This function allows you to optimize the lamp without the use of an external DMX

controller. In this mode, the device will not react to any control signal.

1. Access the main menu.

2. Press UP until “SPEC” is displayed, press ENTER.

3. Press UP until “DFSE” is displayed, press ENTER.

4. The display will show “ON/OFF”.

5. Press UP to display “ON” to activate or “OFF” to deactivate this function.

6. Press ENTER to confirm.

7. Press MODE/ESC to return to the main menu.

DFSE

With this function you can restore the factory default settings of the fixture. All

settings will be set back to the default values. Any edited scenes will be lost. When

restoring the factory settings the unit must be set to the address that the unit was in

when you started editing. When you confirm this function, the fixture will begin to