User manual

www.elationlighting.com!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!"5!!!!!!!!!!!!!!!!!!#!$%&'!(#)!**+!,-./!012314!567
AUTO
Runs the unit without any DMX signal in Stand-Alone mode.
1. Access the main menu.
2. Press UP or DOWN until “PLAY” is displayed, press ENTER.
3. Press UP or DOWN until “AUTO” is displayed, press ENTER.
4. Press UP or DOWN to select “CLOS”, “HOLD”, “AUTO”, or “AUDI” and press
ENTER to confirm.
5. Press MODE/ESC to return to the main menu.
This function dictates how the fixture will function if it looses DMX signal during
normal operation. The default function is set to hold, in which the fixture will lock into
the last DMX signal it received and remain in that position until it is turned off or
begins receiving a new DMX signal. If the fixture is turned on without any DMX
signal, the fixture will automatically go in to sound-active mode. Available settings
are: “Close” – Shutter flags will close. “Hold” – Fixture will remain at its last
settings. “Auto” – Fixture will go into stand-alone mode, running the built-in
program. “Music” – The fixture will go into sound-active mode.
3. RESE (RESET) MENU
ALL - Resets all the motors in the unit.
SCAN - Resets the Pan and Tilt motors.
COLR - (Color) - Resets the color motors.
GOBO - Resets the gobo motors.
OTHR - Reset all other motors
ALL
When you activate this reset function, ALL motors are reset.
1. Access the main menu.
2. Press UP until “RESE” is displayed, press ENTER.
3. Press UP until “ALL” is displayed, press ENTER.
4. Press MODE/ESC to return to the main menu.