User manual

www.elationlighting.com!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!5W!!!!!!!!!!!!!!!!!!#!$%&'!(#)!**+!,-./!012314!567
MAIN FUNCTIONS
0. ADDRESS MENU
AOO1 - A511 (Value) This is where you set the fixtures DMX address.
Setting/Changing the DMX Address
After applying power to the E SPOT LED II™ the LED will display the fixture’s current
DMX address immediately after the reset sequence. If the fixture is not receiving a
DMX signal the display will flash continuously. To set or adjust a DMX address, please
follow the procedure below:
1. Switch on the E SPOT LED II™ and wait for the fixture reset process to finished.
2. Press MODE/ESC to access the main menu. Toggle through the menu by pressing
UP and DOWN until the display shows A001. Press ENTER to make changes to
the DMX address; the current three-digit address will immediately begin to flash.
3. While the current three-digit address is flashing, press UP and DOWN to select
adjust the address. Lock your new address into the unit’s memory by pressing
ENTER. After the new address has been successfully stored into the fixture’s
memory the LED will briefly readout PASS.
The DMX address is non-destructible and will remain in the fixture’s memory even when
power to the fixture has been switched off. Memory is backed-up and retained by an internal
power source with a five year shelf life.
1. TEST MENU
T-01 - T-XX (Test) Tests the functions of channel.
1. Access the main menu.
2. Press UP until “TEST” is displayed, press ENTER.
3. The display will read “T-01”. You can now press UP and test the different channels.
For example: If you press UP until “T-05” is displayed, the unit will test the color
channel, changing the color one by one and show the rainbow effect with different
speeds.
4. Press MODE/ESC to exit.