User manual

www.elationlighting.com!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!5R!!!!!!!!!!!!!!!!!!#!$%&'!(#)!**+!,-./!012314!567
Be sure to follow the above figure when making your own cables. Do not use
the ground lug on the XLR connector. Do not connect the cable’s shield
conductor to the ground lug or allow the shield conductor to come in contact
with the XLR outer casing. Grounding the shield could cause a short circuit
and erratic behavior.
DMX-512 CONTROLLER CONNECTION
Connect the provided XLR cable to the female XLR output of your controller and the other
side to the male XLR input of the E SPOT LED II™ The diagram below illustrates a typical
DMX-512 connection when the fixture is in the 14 Channel Extended Mode. You can chain
multiple panels together through serial linking. The cable that should be used is two
conductor, shielded DMX cable with XLR input and output connectors. Always be sure daisy
chain your in and out data connections, never split or “Y” your DMX connections unless you
are using an approved DMX splitter such as Elation’s Opto Branch 4™, Opto Branch 8™,
or DMX-Branch/4™.
Address 29 Address 15 Address 1