User manual

Power Spot 575IE™
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 24
VTR1
-99 - +99
Software version of Head- board
VTR2
-99 - +99
Software version of Base- board
3.9.9 Default Settings
DFSE
This function is used to restore all the factory default settings and presets. Press
the Enter button to confirm this operation or the Mode button to cancel and return
to the menu. When this operation is selected the LED will briefly readout ok,
then return to the previous function. The chart below details the factory defaults.
Function
Display
Default Settings
DMX Address
D001
D001
Pan reverse
RPAN
ON
OFF 
Tilt reverse
RTLT
ON
OFF 
Automatic lamp on
LAAU
ON
OFF 
Lamp on via DMX
DLOF
ON 
OFF
Display
DISP
D ON 
Cooling fan
FANS
HIGH
REG

LOOF
LOHI
Feedback
FEED
ON 
OFF
3.9.10 Feedback ”APC”
FEED
The POWER SPOT 575IE™ is equipped with ”APC,” automatic position
correction. This function automatically corrects the Pan and Tilt movement should
the unit lose step or is obstructed and forced to lose step. Press the Enter button
to access the sub-menu. Use the Up and Down buttons to toggle between
“ON” and “OFF” and confirm once more with the Enter button or use the Mode
button to cancel the operation.
3.9.11 Error and Fault Corrections
EFLG
(These functions are reserved for authorized technicians only)