User manual

Power Spot 575IE™
©Elation Professionals® Los Angeles, Ca. - wwww.ElationLighting.com - Page 16
3. Fixture Menu
The control panel located on the side of the fixture allows you to access
the main menu and make all necessary adjustments to the POWER
SPOT 575IE™. During normal operation, tapping the “MODE” key
once will access the fixture’s main menu. Once in the main menu you
can navigate through the different functions and access the sub-menus
with the Up and Down buttons. Once you reach a field that requires
adjusting, tap the ENTER button to activate that field and use the UP
and Down button to adjust the field. Tapping the Enter button once
more will confirm your setting. Once a setting is saved the LED will
briefly readout OK to confirm a new setting has been made and locked
into memory. You may exit the main menu at any time without making
any adjustments by tapping the MODE button.
MODE ENTER
UP
DOWN
MODE ENTER UP DOWN
UPMODE ENTER DOWN
Display
Level 1
Level 2
Level 3
Remark
D001
Define the DMX start address
TEST
Test program of all functions
AUDI
ASLW
Self-running audio program (slow)
AFST
Self-running audio program (fast)
MSTR
Master for the audio program
SVPT
Basic position for the audio program
SIZE
Size for the audio program (NORM-BIG-MIDL-SMAL)
LAMP
Switch on/of the lamp direct at the Power Spot 575IE
RESE
Reset
TIME
POWR
Running time of the fixture (non destructible)
LA1
Running time of the lamp (erasable)
LA2
Running time of the lamp (non destructible)
RPAN
Reverse Pan-direction
RTLT
Reverse Tilt-direction
SPEC
MANU
Manual control of all device functions
LAAU
Automatic lamp start
DLOF
Switch off lamp via DMX
DMXI
Reed out actual DMX-values
DISP
D ON
Display On/Off
REV
Flip display readout
TEMP
Displays internal temperature
FANS
HIGH
Maximum cooling fan velocity
REG
Automatic cooling fan control
LOOF
Low cooling fan speed  lamp off
LOHI
Low cooling fan speed  automatic
ADJU
CODE
xxxx
These menu settings are reserved for authorized
technician use only and are protected by a user code.
COLO
Calibration of the color wheel
GOB1
Calibration of gobo wheel 1
GOB2
Calibration of gobo wheel 2
SHTR
Calibration of the shutter
PRIS
Calibration of the prism wheel
IRIS
Calibration of the IRIS
POFS
Calibration of the pan-offset
TOFS
Calibration of the tilt-offset
clre
Clears internal memory (technician only)
ares
Adjust Reset (wheels static after reset)
 DOWN - UP 
VTIL
Software version, tilt pc-board