LIGHT COPILOT II User Instructions (Rev 1.0 24-004-1264) E-mail: info@ elationlighting.com Internet: http://www.elationlighting.
1 Introduction Thank you for your purchase of the LIGHT COPILOT II. The LIGHT COPILOT II is a lighting controller, which can be used together with the LC-8SP relay pack. The LIGHT COPILOT II has a total of 16 Channel outputs available for your convenience. AUDIO and CHASE controls are also available in this unit. A built-in microphone is provided for easy audio control.
Safety Warnings! • To reduce the risk of electrical shock or fire, do not expose this unit to rain or moisture. • Do not spill water or other liquids into or on to your unit. • Do not attempt to remove or break off the ground prong from the electrical cord. This prong is used to reduce the risk of electrical shock and fire in case of an internal short. Do not attempt to operate this unit if the power cord has been frayed or broken. • Disconnect from main power before making any type of connection.
2 Controls and Functions 2.
Used to select the corresponding Chase speed control mode. There are three modes: (1) AUDIO - controlled by audio signals. (2) _x1 - controlled by the SPEED adjuster, the fastest Chase speed can be within a few seconds. (3) 10 min -_controlled by the SPEED adjuster, the slowest Chase speed can be within a few minutes. The left switch controls CH1-4 / CH9-12, and the right switch controls CH5-8 / CH13-16. 14.
2.2.1 Front panel • • Power socket: to output the main power. Power indicator: indicates the status of the power supply. 2.2.2 Rear panel (Relay pack-side view) AC 120V~60Hz, 15A OUTPUT 1 1. 2. 3. 4. CIRCUIT BREAKER INPUT 2 3 AC POWER 4 Signal output: This 9-pin com connection is used to connect another LC-8SP relay pack to the controller unit. Be sure to use only specified ADJ 9-pin com cables.
For example: The EFFECT switch which controls channel 1 can simultaneously control channel 9 in 16-CH mode. The function of each Channel button will be controlled by the FLASH / LATCH selector switch. Select “LATCH” for the LATCH function, and select “FLASH” for the FLASH function. 3.1.3 Chase speed control: Chase speed can be controlled by: a. Audio signals. b. SPEED adjuster in x1 mode. c. SPEED adjuster in 10 min mode.
Warranty 2-YEAR LIMITED WARRANTY A. Elation Professional® hereby warrants, to the original purchaser, Elation Professional® products to be free of manufacturing defects in material and workmanship for a period of two years, (730 days) from the date of purchase. This warranty shall be valid only if the product is purchased within the United States of America, including possessions and territories.
4 Specifications Power input LIGHT COPILOT II…………………………………….………DC 9 ~12V, 500mA min. Power input LC-8SP….…………………….……………………………..AC 120V 60Hz, 15A (max) Channel output…………………………………………………..10A per channel, TOTAL 15A (max) Breaker………………………………………………………………..…………… 15A 250V 5_20mm USB output………………………………………………………………..………..DC 5V 100mA(max) Strobe output……………………………………………………Pulse 10Vp-p(frequency adjustable) Audio input……………………………………………………………………….Line input 0.1V~1Vp-p Dimensions…………………………………………………………………...………..
