Specifications

• The signal output for Switch Pack can be controlled by STAND BY button. When the STAND

BY LED blinks, that means the relevant signal output is disabled. Press the STAND BY

button again (relevant LED “off”) to reactivate the signal output.

3.2 External strobes control

External strobes can be controlled in the following different flash speed modes.

• Switch the “FLASH SPEED selector” to AUDIO mode, the strobes will go sensitively

following the audio signals.

• Switch the “FLASH SPEED selector” to FLASH mode, the strobes will be controlled by the

FLASH SPEED adjuster — adjust towards “Max” to increase the speed level, and adjust

towards “Min” to decrease the speed level.

• Switch the “FLASH SPEED selector” to OFF mode, then the strobes will be disabled.

3.3 Usage of USB light

• When being to use the USB LIGHT, just connect the USB LIGHT to the USB socket on the

front panel of the controller, and then turn on the power switch of the USB LIGHT.

3.4 Fog Machine trigger

• When the HEATING LED is lighted, that means the Fog Machine has been well connected.

• When the READY LED is lighted, that means the Fog Machine is ready to run.

• Press the FOG MACHINE trigger to enable its operating.

4 Specifications

Power input LIGHT COPILOT II…………………………………….………DC 9 ~12V, 500mA min.

Power input LC-4SP….…………………….……………………………..AC 120V 60Hz, 15A (max)

Channel output…………………………………………………..10A per channel, TOTAL 15A (max)

Fuse…………………………………………………………………..……………F 1A 250V 5×20mm

USB output………………………………………………………………..………..DC 5V 100mA(max)

Strobe output……………………………………………………Pulse 10Vp-p( frequency adjustable)

Audio input……………………………………………………………………….Line input 0.1V~1Vp-p

Dimensions…………………………………………………………………...………..480×83×43mm

Weight……………………………………………………………………………………...approx. 1.2kg