Specifications

DESIGN LED 12 BRICK™
©Elation Professional, Los Angeles Ca. 10 www.ElationLighting.com
3. DMX In Jack – This jack accepts an incoming DMX signal via a male, 5-pin XLR jack.
4. DMX Out Jack – This jack is used to send an incoming DMX signal to the next fixture
in the DMX chain via a female, 5-pin XLR jack.
5. DMX In Jack – This jack accepts an incoming DMX signal via a male, 3-pin XLR jack.
6. DMX Out Jack – This jack is used to send an incoming DMX signal to the next fixture
in the DMX chain via a female, 3-pin XLR jack.
7. Eye-Bolt – Use this bold as a safety-cable rigging point. Always secure any
installation with a properly rated safety-cable.
8. Power Input/Fuse Holder Assembly – This assembly holds the safety fuse as well
as provides a female IEC connector for a power cord. Always replace the fuse with an
exact match unless otherwise specified by an authorized Elation Service Technician.
Using a fuse other than that specified could seriously damage the unit and will void
your manufactures warranty.
9. Diffusion Lens – This lens is used to both protect the LEDs as well as diffuse the light
output.
10. Power Output Jack – Use this jack to jump power to another Design LED 12 Brick™
in an array system.
11. Dipswitch Assembly – These dipswitches are used to set the DMX address,
master–slave settings, and other special functions. See the dipswitch chart on page
16 for more information on the dipswitch functions.
12. On/Off Power Switch – Controls main power to the unit.