Specifications

DLED Par Zoom™
©Elation Professional, Los Angeles Ca. 33 www.ElationLighting.com
11. Press [ENTER] to edit the time needed, the display shows “TXXX” , “XXX” stands for
the time needed to run the current scene, value “001-999”. E.g., “002” means you
need 0.4ms (002*0.2ms) to run the current scene. Adjust the desired time by
pressing [UP] or [DOWN] button.
12. Press [ENTER] to save the settings for the scene you are editing, the display will
change to the next scene automatically.
13. Repeat steps 3-14 to edit and other scenes, you can edit and save a maximum of 48
scenes.
14. Press [MENU] to exit. The number of steps can be defined under “STEP” and
the scenes can be called up under “RUN”
Step 1B – Building Scenes from an External DMX Controller
The fixture includes a simple built-in DMX recorder. This recorder allows you to build a
scene using your own DMX console. That scene can then be sent to the fixture and be
stored inside one of the fixture’s scene storage banks. Many people may find this procedure
easier and quicker than using the on board menu functions as in “Step 1.” To store a scene
from an external DMX controller follow the procedures below:
1. Select “SC01” by pressing [UP] or [DOWN] button.
2. Press [ENTER], the display shows “SC01”.
3. Press [ENTER], the display shows “C -01”.
4. Select "CNIN" by pressing [UP] or [DOWN] button.
5. Press [ENTER], the display shows "OFF".
6. Press [UP] or [DOWN] button .the display shows "ON".
7. Press [ENTER], the display shows "SC02". You successfully downloaded the first
scene.
8. Adjust the Step-time as described above under point 12.
9. Call up the second scene in your controller now.
10. Repeat steps 5-11 until all desired scenes are downloaded.
11. Press [MENU] to exit. The number of steps can be defined under “STEP” and
the scenes can be called up under “RUN”.