User manual

www.elationlighting.com!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!4R!!!!!!!!!!!!!!!!!!!!!!#$%&'!(!)*%+!,-#.!/01203!456
1-8 DMX PORT OUPUT
You can set the Port Status of any the DMX Ports 1-4 as Output (OUT). When the Port
Status is set to (OUT), the Port Mode can be set to one of the following (4) modes:
Zero = the port sends out a DMX test signal with all channels at 0%
Single = the port sends out the DMX values of the selected (principal) ArtNet universe. The
DMX output is enabled the first time it detects the DMX universe on the network (or internal
DMX inputs).
LTP = Latest Takes Precedence… Port will output the latest channel activity on
channel-by-channel basis. The unit will compare the principal and secondary universes and
send the latest one to the network.
Please note that in the LTP mode, you should ensure the RESEND option is not
DISABLED or it will NOT RESEND the data to the network.
HTP = Highest Takes Precedence… Like Single, but will merge two DMX universes
(principal and secondary) and will output the one with higher value. The unit will compare
the two universes and resend the higher values to the network. They can be set within the
range of 0.0-F.F.
Please note that in the HTP mode, you should ensure the RESEND option is not
DISABLED or it will NOT RESEND the data to the network.