Instruction manual

1.2 Select an existing node that you use to control the device.
The actual IP address of each node will be listed in the drop down menu.
Node is a drop down menu that displays the actual IP
address of each node.
Outport
Pixel
is a drop down menu that displays the
existing outport of the selected Node.
is a drop down menu that displays the existing
pixel map address of the selected Outport.
Dimming Area Operation
Work Grid features to adjust
the brightness
1.1 In the main folder, click the "Runproj"( ) icon to enable your X-Software. The X-Software will show you
the following screen.
Before running X-Software, it is advisable to check how many nodes are used to control the device
and review all the settings in Mapping Operation.
1.3 Select an existing outport of the selected node to control the device. The outports are set by default.
-23-