Instruction manual

6. Create a Pixel Map
After all devices and fixtures settings are finished, access to built a pixel map as needed.
Device Select is a drop down menu that displays existing device which you wish to assign the device
to the Pixel Map.
Node Address is a drop down menu that displays existing nodes which you wish to use to control
your devices actually.
Select Output is a drop down menu that displays existing output port of selected node which you
wish to use to control your devices actually.
To create a Pixel Map, simply follow these steps;
6.1. Select an existing device which you wish to create a pixel map.
6.2. Select an existing node which you to use to control device.
6.3. Select an existing output port of selected node to control device.
6.4. Click the grey area in Work Grid till Arrow( )turn red, Grid( )turn green in Toolbar.
6.5. Then click the Grid( ) to array device's pixels and create the pixel map.
6.6. After placing the pixel map as needed, click Arrow( ) then click the pixel map assign devices pixels
direction according to the scan order which has been set up.
Existing Device Info Tab
Toolbar
-19-