Specifications

Elation Professional - www.elationlighting.com - Page 9

• Should the DMX signals be disabled, operation can be done manually.

6.4 DMX TRIGGER mode

• In this mode, the first four DMX channels (Ch1~Ch4) can be used to respectively

control

I01~I04 sequences. I01~I04 sequences will run when the DMX level of each

relative channel !20%. These sequences will stop running when the correspondent

level _20%.

• The DMX trigger will only operate when it is receiving a DMX signal.

• Sequences (including STARTUP and SHUTDOWN) can be operated manually in

DMX TRIGGER mode.

6.5 PROGRAM mode

In this mode, any one of the sequences can be recorded, and the sequence name

can also be changed.

6.5.1 Recording operation

• Select the sequence to be recorded (including the internal sequences and the

external sequences). Remember: The CF card must be formatted before use.

• Check DMX indicator. When the correspondent LED is “on”, the unit is receiving a

DMX signal, when the LED is “off” the unit is not receiving a DMX signal.

• Press the RECORD button, the sequence control will be paused, and the

correspondent data will be erased.

• Press the PAUSE or PLAY button to record. Then press the STOP button to stop the

operation at any moment you want.

• Warning: during operation, please do not turn off the unit, otherwise the

correspondent recorded data will be missing.

6.5.2 Changing the sequence name

• In PRG Mode, when the unit is “STOPPED”, press the “Enter” button to enter the

menu, an underline will appear in the top left corner of the LCD-display.

• Press the NEXT button to move to the selected character, and use UP/DOWN

buttons to change the correspondent characters. Press ENTER button to confirm

your operation.

• The Smpte time will not change while changing the sequence name.

6.6 SETUP mode

Seven items are offered and can be selected in this SETUP mode as below.

(1) Smpte Trig : enter this submenu to trigger the Smpte signals and to set the trigger

time. Press the NEXT button, and then use the UP / DOWN buttons to choose Yes