User manual

DMX PARTNER
07
Section 7: Recording Shows
1. Connect from your DMX controllers output to the DMX input o f your DMX Partner. (When
programming moving lig hts, it is recommended that you pre program scenes into your DMX controller
before recording shows into the DMX Partner. If your programming conventional dimmers, you can
record them in real time using your controllers dimmer channels).
2. Press and hold down the “Record“ button and simultaneously press show buttons 1, 6, 8,1, 6, 8 in
sequence. As a result, the record LED will illuminate. (Note: if you do not have a DMX controller
connected to the DMX input of the DMX Partner as described in the previous step, you will not be
able to access the Record mode).
3. Select the Show buttons 1-10 that you want to record into. Once selected, the show LED will
continually flash and the LED will display the current show step- “SH:00“.
4. From your DMX controller, select the scene or manually adjust the channels you want included into
your first show step.
5. Adjust the steps hold time by pressing the “SPEED“ button. Next, use the “UP/DOWN“ buttons to
select the hold time ranging from 0.1 (one tenth of a second) to 10:00 (ten minutes).
6. Adjust the steps fade time by pressing the “FADE“ button. Next, use the “UP/DOWN“ buttons to
select the fade time ranging from 0.1 (one tenth of a second) to 10:00 (ten minutes).
7. To record the step, press “Record“.
All ten show LEDs will momentarily flash and the LED will
display the next show step confirming that your step has been recorded.
8. Repeat steps 4-7 up to 99 times per show.
9. Press “BLACK-OUT“ twice t o exit record mode.