User manual

DMX PARTNER
10
Section 10: Show Playback
Shows can be played back in two modes- “Sequence“ or “Mix“. Sequence mode allows for shows to
be played back one at a time. Ten shows can be selected at one time. However, the show with the
flashing LED is the only active show running at the given time. Once that show has finished, the next
selected show will automatically begin to run and it’s LED will begin to flash until it finishes. This
sequence mode will automatically loop both shows continuously. Mix mode allows ten shows to be
played back at any one time. This mode allows for the highest values to take effect over a given
channel. For example, if one show contains a value of 161 for channel 3 and the other show contains
a value of 223 for channel 3 then the show containing the value of 223 will take precedence because
it is a higher value. This mode works very well with moving lights.
10a. Sequencing show playback
1. Press show buttons 1-10 . The active show LED will flash continuously and the LED will display
the selected show number followed by the sequencing show steps- "S1-10:1-99". (Note: in this mode
the shows will continue to loop from one to the other. Speed and Fade buttons do not have any effect
in show playback as speed and fade times were recorded in show record mode).
2. To disengage a show, press the show button you wish to turn off. The show button LED will turn
off confirming that it will no longer be included in the sequence.
10b. Mix show playback
1. Press and hold down any one of the 10 show buttons, then press the other show button and
release all simultaneously. The selected show LED’s will then flash continuously indicating that they are
in mix show playback mode.
2. To exit this mode, press each show button twice.
Section 11: Strobe Playback
The strobe function will mix with any current running show.
1. Press the “STROBE“ button when effect is desired.
2. Press the “STROBE“ button again when you want the strobe effect switched OFF.