PROFESSIONAL WIRELESS DMX CONTROLLER USER’S MANUAL EWDMXSYSTEM KEEP THIS MANUAL FOR FUTURE NEEDS For your own safety, please read this user manual carefully before installing the device.
Keep this device away from rain and moisture ! Unplug mains lead before opening the housing. Every person involved with the installation, operation and maintenance of this device has to: - be qualified - follow carefully the instructions of this manual SAFETY INSTRUCTIONS This device has left our premises in absolutely perfect condition.
Keep away children and amateurs from the device! There are no serviceable parts inside the device. Maintenance and service operations are only to be carried out by authorized dealers. OPERATING DETERMINATIONS This device is a wireles DMX receiver for transmitting DMX-data without cables. This product is allowed to be operated with a direct voltage of DC 6-12 V, 1 A and was designed for indoor use only. Do not shake the device. Avoid brute force when installing or operating the device.
damages are the result of unprofessional operation! Please use the original packaging if the device is to be transported. Please consider that unauthorized modifications on the device are forbidden due to safety reasons!] Never remove the serial barcode from the device as this would make the guarantee void. If this device will be operated in any way different to the one described in this manual, the product may suffer damages and the guarantee becomes void.
(1) (2) (3) (4) Power switch Antennat Status-LED Function-button (5) DMX-Out socket (3 pin) (6) DMX-Out socket (5 pin) (7) USB-jack (The USB jack is not activated at this version, it is for future expansion only!) (8)Status-LED (9)RJ-45 jack (The RJ-45 jack is not activated at this version, it is for future expansion only!) (10) Power supply -5-
SETUP Installation Install the device on a plane surface. Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet. With the POWER-switch, you can switch the device on and off. Clamp mounting drawing DMX-512 connection The wires must not come into contact with each other, otherwise the fixtures will not work at all, or will not work properly.
Building a serial DMX-chain: Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always connect one output with the input of the next fixture until all fixtures are connected. OPERATION 1. Equipments in a link DMX 512 controller , wireless transmitter , wireless receiver , and lighting fixture 2.
Case 1: Remove a receiver: a) Press and hold the configuration button on receiver for 3~ 10 seconds; b) The LED on the receiver will turn to Solid red; the receiver can log out from the transmitter (T1); c) press the configuration button on transmitter(T2) for less than 3 second, then the fixture will start to connect with the transmitter(T2) Case 2: Remove all receivers from a transmitter (T1) to log in to T2; a) Press and hold the configuration button on the T1 as least 5 seconds, can clear the connection
