User manual

70
2004 software Manual
5.5 Hints and tips
5.5.1 Using "INIT" button
On each page, there is a special scene called "INIT" in the top-left corner. It is important to become
familiar with what this scene is used for:
·
Whenever the software is started, each page will automatically play its own "INIT" scene.
·
When you create a new scene, it will always be a copy of the "INIT" scene.
It is therefore recommended to adjust "INIT" scenes to your requirements.
NB : it is impossible to delete or rename "INIT" scene.
5.5.2 Installing several software-disks
It is possible to install a disk several times, which a show-organizer may find useful and convenient
to save different configurations. To archieve this, a different file should be selected each time, when
installing the software. Each disk will then be displaying in Windows "Start Program" menu.
5.5.3 Using several USB Interfaces
2004 Software is operational up to 10 simultaneous interfaces, that is 5120 channels as a whole.
However beware that the more interfaces you use, the more computer resources are requested. A
performant computer would then be needed.
Connect all interfaces before starting on your computer in order to proceed to
programming. If not so, the cards order could be inverted next time your computer get
started. Your programming would consequently lose coherence. Would you proceed
to computer or interface reinstallation, prefer to start again computer before opening
software.