User manual

2004 software Manual

5.2.2 Setting channel level manually

Channels can be set by means of five different modes. Within the default mode each particular

channel is represented by a red icon bearing AUTO. With this activated mode, scene or switches

have priority. If you wish to set channel manually, click right. The following menu appears on

screen:

Five channel control modes are at your disposal :

LTP : Manual mode has always priority.

HTP : The highest level between manual mode and programmed scenes or switches has priority.

For instance, let us suppose channel is adjusted at 50%, this channel may get a higher value but

not a lower one.

Low TP : The lowest level has priority.

ADD : Manual setting value is added to the one programmed in scene or switches button. For

instance, supposing manual setting is 10%, the button corresponding to the same channel will be

up 10%.

SUB : Unlike the former one, manual setting is removed from the programmed level in scene or

switches button.

Several channels may be simultaneously set on the same level. To do so, press F1 or click the

following button :

A window appears as follows :

Those settings may be either saved within a switch or be straight displayed in the outputs window.

Watch out that in such a case settings are displayed... but not saved !