User manual

37
2004 software Manual
Now a little training...
Things will go smoothly once the channel has been set in "EasyTime" mode as was done for "On" or
"Dimmer" modes.
Just click "EasyTime" mode to pilot all the channels required in "EasyTime" mode (click and drag
leds). Now just scroll the time-sheet to time-indication. To set value, just move the fader. The value
will be displayed in the cell concerned, i.e. at the channel column concerned.
You must move the cursor to the line corresponding on the total expected time for
your scene before to setup your channels with EasyTime function. For example : for a
10s scene, we move the cursor (yellow line) to the 00m10s00 line and then we affect
EasyTime function on selected channels.
In case there are blank cells in between the latest time programmed and current time, you will be
prompted to answer the following questions :
·
Prolong previous value up to current time?
·
Gradually move from previous value to new value?
·
Assign new value from latest cell programmed onwards ?
Type, click on an Easy Time column figure to open the following menu :
This menu allows to change the way steps are linked together. "Linking"
may be set according to tempo or programmed on step-by-step mode.