User manual

26
2004 software Manual
4.3.2 How to make a fade between two scenes
It is possible to fade from one scene to another one. For instance, this is really useful to go from one
position to another one very slowly, to open/close the dimmer of your lights...A few things need to be
checked before to start programming our 2 scenes. First of all the "FADE" function must be allowed
on the channels we want to use. To do so, we open the "Page Settings..." window from the menu
and we go to the "Channels" tab (see below).
All the channels of our page are listed in the list situated on the left side of the window. We want to
make a fade between 2 positions, so we must enable the "FADE" function on Pan&Tilt channels for
all our fixtures. Please note that the function is already enable on Pan&Tilt channels...however this
is good to see how to do it. Now it is time to create our 2 scenes. In the previous chapter we saw
how to create a scene "As you see now"...we will use the same function and create the scenes using
the TAKE buttons.