User manual

2004 software Manual

How to operate LTP switches

LTP-priority is the mots commonly-used mode for Switch buttons it is therefore important to have

good command of this mode. The basic principle is: "the latest LTP switch which is activated takes

priority."

Caution: this priority can only apply on the channels required. In the case of moving light, the "Gobo"

Switches will only operate on the channels corresponding to the Gobos and will have no effect

whatsoever on the overs channels. This selection can simply be made via the OFF function. The

OFF channels in an LTP switch will not be operational !

Therefore the DIMMER function on 0% and the OFF function produce different results in an LTP

switch :

if the channel is on OFF, activating the switch will have no effect on the channel concerned.

if the channel is on DIMMER 0%, activating the switch will force the channel concerned down to 0%.

LPT switches also have a "Auto-release" mode.

For example, with several switches used for selecting different gobos, if "Auto-release" mode is

activated on these switches, clicking on "GOBO-STAR" will automatically release the "GOBO-

CIRCLE" switch which was previously pressed.

NB : Auto-releasing among several LTP switches will be fully-operational provided the switches

operate on the same channels (i.e. OFF functions on the same channels).