Specifications

DESIGN LED 36™
©Elation Professional, Los Angeles Ca. 17 www.ElationLighting.com
fixture.
In the case of the Design LED 36™, which is a 6 channel fixture, you should set the
starting DMX address of the first unit to 1, the second unit to 7 (6 + 1), the third unit
to 13 (6 + 7), and so on. The chart on page 19 details the proper starting DMX address
dipswitch setting combination.
NOTE: The Design LED 36 contains a total of 12 dipswitches. Only use dipswitches
1~9 to set the DMX address. Dipswitches 10~12 are used for special functions that
will be explained later in this manual.
Dipswitch 12: Mode Selection, when in the “OFF” position the fixture functions in
default mode, which is 6 DMX channels. When in the “ON” position the fixture
functions in 3 DMX channels for simple RGB operation.
Dipswitch 10 on & 11 off: Sound-active operation when used as a single stand-alone
unit or “master” unit.
Dipswitch 10 on and 11 on: Fixture functions as a “slave” unit in sound-active
operation.
Dipswitch 10 off and 11 on: Unit will function in manual mode, see chart below for
manual settings.
Manual Settings:
Manual static settings are achieved when dipswitch 7 is in the “off” position.
RED:
Dipswitch 1 & 2 off, the red value is 0
Dipswitch 1 is on and dipswitch 2 is off, the red value is 60
Dipswitch 1 is off and dipswitch 2 is on, the red value is 125
Dipswitch 1 is on and dipswitch 2 is on, the red value is 255